2015 Chrysler 200 Powertrain / Transmission Problems
667 owner complaints · median failure at 40,000 miles · typical repair $2,500
The 2015 Chrysler 200 has 667 owner complaints about powertrain / transmission problems filed with NHTSA, typically reported around 40,000 miles with a typical repair estimate of $2,500. Related reports include 20 alleged crashes, 11 alleged injuries.
Failure profile
| Complaints filed (NHTSA) | 667 |
|---|---|
| Failure mileage — 25th percentile | 14,390 mi |
| Failure mileage — median | 40,000 mi |
| Failure mileage — 75th percentile | 69,000 mi |
| Typical repair estimate | $2,500 |
| Severity rating | Moderate |
| Related serious reports | 0 alleged fires, 20 alleged crashes, 11 alleged injuries |
How the 2015 Chrysler 200 compares
This model year is #11 of 465 published powertrain / transmission patterns by complaint volume, and accounts for 0.89% of the complaints in this category's published patterns — which covers 1,310 model-year patterns with recorded failure mileage.
Reported failures on the 2015 Chrysler 200 arrive at a median of 40,000 miles, which is 37% earlier than the 63,000-mile category median. That gap matters more than the raw complaint count: a part that fails early leaves less of the repair bill covered by warranty, and it points at wear that may be specific to this generation.
Other 200 model years
| Model year | Complaints | Median failure |
|---|---|---|
| 2013 | 54 | 39,754 mi |
| 2015 (this page) | 667 | 40,000 mi |
| 2016 | 59 | 42,000 mi |
Read this table as a shape, not a league table: if several nearby model years carry similar volume and similar mileage, the fault belongs to the generation as a whole; if one year stands well above its neighbours, that year is the one to inspect before buying.
Symptoms to watch for
- Slipping or flaring between gears
- Harsh or delayed engagement when cold
- Shudder or vibration at steady speed
- Whine, clunk or a thump on throttle changes
- Fluid leaking or smelling burnt
The full description of each symptom, and what it usually means, is on the powertrain / transmission problems hub.
Most likely causes
- Fluid level or fluid degradation (common) — Check level by the manufacturer's procedure (some units require the engine running and a specific temperature) and smell the fluid.
- Solenoid, valve body or pressure fault (common) — Transmission codes plus a live slip measurement; a valve body repair is far cheaper than a rebuild.
- Clutch-pack or band wear (less common) — Confirmed by teardown or by consistent slip under load after fluid and pressure are ruled out.
- CVT belt or chain wear (less common) — CVT whine plus metal debris in the fluid; on most CVTs this ends in replacement, not repair.
- Mounts, axles or driveshaft (occasional) — Clunk on throttle tip-in with no slip in the data usually means a mount or a worn CV joint, not the transmission.
Frequency labels are qualitative editorial guidance, not measured rates from the complaint data.
Diagnose before you pay
- Check fluid level and condition by the book, then scan the transmission computer for codes and pending codes.
- Road-test with live data to see whether the unit is slipping, or whether the engine is losing power and the transmission is blamed for it.
- Do not flush a high-mileage unit with unknown history as a diagnostic step — a service can finish a transmission that was already failing.
When to stop driving: Stop if the transmission slips out of gear, refuses to engage, or dumps fluid. Driving a slipping unit burns the clutches and turns a valve-body repair into a replacement.
What this means for owners
- Check open recalls first. A manufacturer recall covering this component means the repair is free at a dealer — the 2015 Chrysler 200 recall list is on the model year page.
- Reported, not proven. These are unverified owner complaints. Volume shows a pattern worth checking with a dealer or mechanic, not a confirmed defect in every vehicle.
- Mileage is a guide, not a schedule. Half of the reported failures happened before the median mileage and half after — maintenance history and driving conditions move that point a lot.
- Compare within the model line. If this component also fails early on adjacent model years, the pattern is stronger than a single-year spike.
People also ask
Does the 2015 Chrysler 200 have powertrain / transmission problems?
Owners have filed 667 powertrain / transmission-related complaints for this model year, most commonly around 40,000 miles. Complaints are unverified owner reports — check open recalls and service bulletins before assuming a defect.
When does the 2015 Chrysler 200 fail in this area?
The median failure mileage for powertrain / transmission issues on this model year is 40,000 miles (25th percentile 14,390, 75th percentile 69,000).
How much does the repair cost?
The typical repair estimate for this failure pattern is $2,500. Actual costs vary by shop, region and whether the part is repaired or replaced.
Other components on the 2015 Chrysler 200
electrical (535) · airbags & restraints (194) · engine (153) · steering (86) · suspension (54)
Related OBD-II diagnostic codes for powertrain / transmission issues: P0700
Source: ProblemsByVin (CC BY 4.0), aggregated from public NHTSA complaint data. Owner complaints are unverified. See Data Sources & Methodology. VinSpecs is an independent service, not affiliated with NHTSA or any manufacturer.